EarthWay 2170T Tow Montaj ve Kullanım Talimatları Kılavuzu - Sayfa 4
Serpme EarthWay 2170T Tow için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları Kılavuzu indirin. EarthWay 2170T Tow 6 sayfaları. Broadcast spreader
Sayfayı Yazdır
15.
Install the two 1/4-20 x 1" Stainless Steel bolts into holes lo-
cated on each side of the hopper and secure with 1/4-20 lock-nut.
Next slide Debris Screen under the two bolts inside the hopper.
17.
Pull lever back to setting "30" as shown. Next push pivot &
bracket forward so that the shut off plate in the hopper is in the full
open position. REMEMBER SETTING "30" ON THE FLOW
CONTROL LEVER MUST PLACE THE SHUT-OFF PLATE
IN THE FULL OPEN POSITION TO BE PROPERLY CALI-
BRATED. Now tighten the nuts against the pivot bracket to pre-
vent change in calibration.
13.
Attach gauge and lever assembly to control support using (2) 1/4-20
x 1 1/2" bolts and (2) 1/4-20 locknuts. TIGHTEN NOW. Now tap with
hammer 1" hole plug into control support.
16.
Install flattened end of control rod in to lever on gauge as
shown. Turn to lock in place. Next push lever forward to setting
"0". Align control rod with hole in pivot bracket, pull lever
backward to insert control rod through hole in pivot bracket.
Now install 1/4-20 regular nut on to control rod.
DO NOT TIGHTEN NUTS YET.
18.
Insert agitator to pinion shaft on inside of hopper. N
position of flat side of the agitator. This pin should be
stalled as shown.
14.
Install (1) 1/4-20 regu-
lar nut (not a locknut) on to
control rod as shown.
: the
OTE
in-
PAGE 4