Miele DDG 102 Çalıştırma ve Kurulum Talimatları - Sayfa 19

Havalandırma Davlumbazı Miele DDG 102 için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. Miele DDG 102 28 sayfaları. External motor roof installation
Ayrıca Miele DDG 102 için: Kullanım ve Kurulum Kılavuzu (24 sayfalar), Kurulum Talimatları Kılavuzu (28 sayfalar), Kurulum Talimatları Kılavuzu (28 sayfalar)

DDF 125/150

* Flashing

The roof vent can be used for installing

venting through pitched tiled, pantiled,

slate or shingle roofs; the slope of the

roof must be at least 22° to prevent the

ingress of rain or snow.

Consult a roofer for advice regarding

other types of roofing.

The roof vent is not suitable for

installation on flat roofs.

Installation must only be carried out

by a qualified competent person.

^ Remove the roofing around the

installation area.

^ Bend the flashing upwards.

^ Position the roof vent on the roof with

the air outlet directed down the roof.

^ Secure the roof vent to the roof

substructure with the fixing plate.

^ Replace the roofing. Press down on

the flashing to ensure that it creates a

proper seal.

The flashing should be fitted under

the roofing at the top of the roof vent

and above the roofing at the sides

and the bottom of the roof vent.

The roof vent stub has a diameter of

150 mm when the appliance is

supplied. An adapter is supplied for

use with 125 mm ducting.

^ If a diameter of 150 mm is required,

the front ring of the stub must be cut

off at the join with a sharp knife (see

illustration).

^ Push the flexible ducting onto the

stub and secure it with a hose clip.

It has an integrated non-return flap.

Important: when feeding the exhaust

ducting through the substructure of the

roof be careful to ensure that any gaps

are sealed up properly afterwards.

Installation