Miele PT 8401 Kullanım Talimatları Kılavuzu - Sayfa 14
Kurutucu Miele PT 8401 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Miele PT 8401 26 sayfaları.
Sayfayı Yazdır
Drying
At the end of the programme:
^ Open the drum door.
^ Unload the drum.
Make sure nothing is left behind in the drum. If
items are left in the dryer, they could be damaged
by overdrying when the dryer is next used.
,
Do not unload laundry from the drum until the
cooling down phase has been completed.
Hot laundry can self-ignite and cause a fire when
folded or put away.
^ Check the fluff filter and clean if necessary. Close
the fluff filter compartment flap to prevent anyone
tripping over it.
If the dryer is still switched on (and the drum door
is closed) it will start up again briefly after an inter-
val of 30 minutes for safety reasons.
14
Interrupting a programme
The programme is interrupted by:
- pressing the mains On/Off switch s,
- opening the drum door,
- opening the fluff compartment flap.
To continue the programme:
Press the mains On/Off switch s, or close the drum
door or fluff compartment flap.
The remaining drying duration or the target residual
moisture level will flash in the segment display, and a
cooling-down phase will follow the end of the
programme.
^ Press the START/STOP button or remove the laun-
dry straight away.
Adding or removing items
The drum door can be opened during a drying
programme to remove or add items if necessary.
,
Always make sure that the drum is stationary
before reaching into the machine to remove laun-
dry. Reaching into a moving drum is extremely
dangerous.
To continue the drying programme:
^ Close the drum door.
The remaining drying duration or the target residual
moisture level will flash in the segment display.
The fan will switch itself on automatically if the
temperature in the drum is too high.
^ Press the START/STOP button to continue the
programme.
If no more laundry is to be processed:
^ Close the drum door.
^ Switch the dryer off by pressing the mains On/Off
switch s
^ Switch off the on-site mains switch.
^ Close all stopcocks for water, gas and steam as
applicable.