Miele KM 34 Series Teknik Bilgiler - Sayfa 19

Setüstü Ocak Miele KM 34 Series için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Miele KM 34 Series 25 sayfaları.

KM 34xx Gas Cooktops

Note:

Carry out the following after reassembly: Leakage Test, Section 020-4.8,

Burning Properties Test, Section 010-4.7, and Automatic Re-Ignition

Test, Section 010-4.9.

4.7

Burning Properties Test

4.7.1

Note:

Check the burning properties of every burner.

1. Connect the cooktop to the power supply.

2. Connect the cooktop to the gas supply.

3. Turn the switch knob counterclockwise to the highest setting (Figure 010-18,

Item 1) and release it.

4. The gas flame must burn with a clear, distinct core.

5. Rapidly turn the switch knob from the highest setting (Figure 010-18, Item 1)

to the low flame setting (Figure 010-18, Item 2).

6. If the flame goes out, check whether the burner head openings are blocked.

7. Clean the burner head, if necessary.

8. If the flame goes out again, check whether the correct jets are installed for

the type of gas in use (see Table C-3).

9. If incorrect jets are installed, replace them with jets with the correct diameter.

10. Check whether the flame burns at the low setting; see Figure 010-18, Item 2.

11. If the flame goes out, check whether a draft is the cause.

12. If this is not the cause, then possibly the thermocouple is not being heated

sufficiently; see Thermocouple Test, Section 010-4.8.

4.7.2

Note:

Check the burning properties of every burner.

1. Connect the cooktop to the power supply.

2. Connect the cooktop to the gas supply.

3. To check the burning properties of the outer and inner flame rings, turn the

switch knob counterclockwise to the highest setting (Figure 010-17, Items 1

and 3) and release it.

Technical Information

1 High setting

2 Low setting