Miller Axcess 300 Kullanıcı El Kitabı - Sayfa 24
Kaynak Sistemi Miller Axcess 300 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller Axcess 300 44 sayfaları. Arc welding power source and wire feeder with meters
Ayrıca Miller Axcess 300 için: Kullanıcı El Kitabı (36 sayfalar), Kullanıcı El Kitabı (48 sayfalar)
Sayfayı Yazdır
SECTION 5 − MAINTENANCE &TROUBLESHOOTING
5-1. Routine Maintenance
3 Months
Replace unreadable labels
Clean and tighten weld terminals
6 Months
Blow out or vacuum inside.
5-2. Circuit Breaker CB1
1
5-3. Overheating
Thermostats TP2 and TP3 protect the unit from damage due to overheating. If main transformer T1 or rectifier Z1 gets
too hot, TP2 and/or TP3 opens and output stops. The fan keeps running to cool the unit. Wait several minutes before
trying to weld.
OM-1321 Page 20
Repair or replace
cracked weld cable
OR
3
Y Disconnect power
before maintaining.
Check gun
cable.
Clean
drive rolls.
1
Circuit Breaker CB1
If CB1 opens, wire feeding stops.
2
Welding Gun (Not Included)
Check gun liner for blockage or
kinks.
3
Wire Drive Assembly
Check for jammed wire, binding
drive gear or misaligned drive rolls.
2
Allow cooling period and reset
breaker. Close door.
.
Maintain more often
during severe conditions.
Ref. 802 517-A