Miller CST 280 Kullanıcı El Kitabı - Sayfa 29
Kaynak Sistemi Miller CST 280 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller CST 280 48 sayfaları. Dual rack kit
Ayrıca Miller CST 280 için: Kullanıcı El Kitabı (28 sayfalar)
Sayfayı Yazdır
4-3.
Stick Start Procedure − Scratch Start Technique
4-4. Lift-Arc™ Start Procedure
Lift-Arc Start Method
1
3
1
1 − 2
"Touch"
Seconds
Do NOT Strike Like A Match!
2
2
With Stick selected, start arc as
follows:
1
Electrode
2
Workpiece
3
Arc
Drag electrode across workpiece like
striking a match; lift electrode slightly
after touching work. If arc goes out
electrode was lifted to high. If
electrode sticks to workpiece, use a
quick twist to free it.
VRD
Model
Only:
Normal
open-circuit voltage is not present
before electrode touches workpiece;
only a low sensing voltage is present
between electrode and workpiece.
This allows electrode to touch
workpiece
without
overheating,
sticking, or getting contaminated.
Lift-Arc Start
With Lift-Arct selected, start arc
as follows:
1
TIG Electrode
2
Workpiece
Turn gas on. Touch tungsten
electrode to workpiece at weld start
point.
Hold
electrode
workpiece for 1-2 seconds, and
slowly lift electrode. Arc is formed
when electrode is lifted.
Normal open-circuit voltage is not
present before tungsten electrode
touches workpiece; only a low
sensing voltage is present between
electrode and workpiece. The
solid-state output contactor does
not energize until after electrode is
touching workpiece. This allows
electrode to
touch workpiece
without overheating, sticking, or
getting contaminated.
Application:
Lift-Arc is used for the DCEN
GTAW process when HF Start
method is not permitted, or to
replace the scratch method.
OM-217 655 Page 25
to