Miller CST 282 Kullanıcı El Kitabı - Sayfa 33

Kaynak Sistemi Miller CST 282 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller CST 282 42 sayfaları.

7-4.

Troubleshooting

Trouble

Line Disconnect Open.

No weld output, unit

completely

Blown fuses.

Inoperative

Improper input connections.

Faulty output diode(s) D1 or D2 or D3

No weld output

Faulty HD1

Weld cables too small or defective.

Erratic or improper

weld output

Dirty or loose connections.

Blocked fan.

Fan not operating

Fan Failure

�

Complete Parts List is available at www.MillerWelds.com

Possible Causes

Remedy

Place line disconnect switch in On position. (See section

5-8 or 5-9)

Check and replace line fuses, if necessary, or reset circuit

breaker. (See section 5-8 or 5-9)

Check for proper input connections. (See section 5-8 or

5-9)

Check for shorts or opens in wiring.

Have factory authorized service agent check HD1.

Use proper size and type of weld cable. (See section 5-2)

Clean and tighten all weld cable connections. (See Sec-

tion 5-4)

Check for and remove anything blocking fan movement.

Have factory authorized service agent check fan motor.

OM-285986 Page 27