Burkert 2300 Series Ek Talimatlar - Sayfa 7

Valf Konumlandırıcılar Burkert 2300 Series için çevrimiçi göz atın veya pdf Ek Talimatlar indirin. Burkert 2300 Series 12 sayfaları. Remote-positioner, installation on process valves with internal air flow
Ayrıca Burkert 2300 Series için: Kullanım Talimatları Kılavuzu (12 sayfalar), Hızlı Başlangıç Kılavuzu (19 sayfalar)

Sayfayı Yazdır

Type 8635, Remote-Positioner

Assembling the position sensor

Fastening screws

(2x)

Fig. 9:

Attachment of the position sensor

NOTE!

Observe tightening torque when attaching the position

sensor.

If the fastening screws are tightened too tightly, the degree of

protection IP65 and IP 67 is no longer guaranteed.

▶ Tighten the fastening screws to a maximum tightening

torque of 1.5 Nm.

→ Attach position sensor to the actuator using the two side

fastening screws. Observe maximum tightening torque

of 1.5 Nm.

3.3

Pneumatic connection of the position

sensor

DANGER!

Risk of injury from high pressure and discharge of medium.

▶ Before working on the device or system, switch off the pres-

sure. Vent or drain lines.

Port 1

Port 3:

not used, internally sealed

Fig. 10: Pneumatic connection

english

Port 3