Miller 1038 Operatör El Kitabı - Sayfa 10

Kamera Aksesuarları Miller 1038 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Miller 1038 12 sayfaları. Fluid head

Maintenance

The Compass 25 Fluid Head offers high quality surface

coatings. Miller recommends keeping the Fluid Head clean at

all times by using soft brushes and lint free cloth to wipe over

the surfaces.

•

Do not immerse the Fluid Head in any liquid.

•

Do not use stiff brushes, abrasives, harsh detergents and

solvents.

•

B a t t e r y R e p l a c e m e n t .

The Compass 25 Fluid Head uses a single 11A type - 6 Volt

battery for Illumination. Miller recommends the following

batteries to provide long life performance – GP11A, Duracell

MN11 or Vinnic L1016.

Using a Phillips Head #1 screw driver, remove the

RETAINING SCREW and the BATTERY DOOR.

Using a small flat screw driver remove the battery.

Align the new battery as shown on the back of the

BATTERY DOOR and place into the BATTERY

HOUSING, then push down the battery into place. A

small flat screw driver may be used to push down the

battery into the BATTERY HOUSING.

Align the BATTERY DOOR into the body then tighten the

screw lightly.

Battery Housing

Retaining Screw

Fig. 8

Illumination Button

Battery Door

Battery