Miller 1038 Посібник оператора - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник оператора для Аксесуари для фотоапаратів Miller 1038. Miller 1038 12 сторінок. Fluid head

Miller 1038 Посібник оператора

Maintenance

The Compass 25 Fluid Head offers high quality surface
coatings. Miller recommends keeping the Fluid Head clean at
all times by using soft brushes and lint free cloth to wipe over
the surfaces.
Do not immerse the Fluid Head in any liquid.
Do not use stiff brushes, abrasives, harsh detergents and
solvents.
B a t t e r y R e p l a c e m e n t .
The Compass 25 Fluid Head uses a single 11A type - 6 Volt
battery for Illumination. Miller recommends the following
batteries to provide long life performance – GP11A, Duracell
MN11 or Vinnic L1016.
1
Using a Phillips Head #1 screw driver, remove the
RETAINING SCREW and the BATTERY DOOR.
2
Using a small flat screw driver remove the battery.
3
Align the new battery as shown on the back of the
BATTERY DOOR and place into the BATTERY
HOUSING, then push down the battery into place. A
small flat screw driver may be used to push down the
battery into the BATTERY HOUSING.
4
Align the BATTERY DOOR into the body then tighten the
screw lightly.
Battery Housing
Retaining Screw
Fig. 8
10
Illumination Button
Battery Door
Battery