Miller Digital Elite Manuel - Sayfa 13
Motosiklet Aksesuarları Miller Digital Elite için çevrimiçi göz atın veya pdf Manuel indirin. Miller Digital Elite 28 sayfaları. Auto-darkening helmets
Ayrıca Miller Digital Elite için: Manuel (32 sayfalar)
Sayfayı Yazdır
4-6. Sensitivity Control
1
Sensitivity Adjustment
Buttons
2
Mode Control Button
Use control to make the lens
more responsive to different
light levels in various welding
processes. Use a Mid-Range
or 30−50% sensitivity set-
ting for most applications.
It may be necessary to adjust
helmet sensitivity to accom-
modate
different
conditions or if lens is flashing
On and Off.
The sensitivity ranges for
each mode are as follows:
Weld, Cut, X-Modes − 0–10
Grind Mode − No sensitivity
adjustment
!
Do not weld in the Grind
mode; the lens will not
darken.
Stick Electrode
Short Circuiting (MIG)
Pulsed & Spray (MIG)
Gas Tungsten Arc (TIG)
Plasma Arc Cutting/Welding
Digital Elite Lens Shown
.
X-Mode is not present on
Performance helmets.
Sensitivity Adjustment
Procedure
.
Adjust helmet sensitivity
in lighting conditions hel-
met will be used in.
lighting
S
Press Auto On/Off button
to turn helmet On.
S
Press Mode button to se-
lect
Weld, Cut, or X-Mode.
S
Use Sensitivity Less and
More buttons to adjust
sensitivity control to low-
est setting.
Recommended Sensitivity Settings
desired
function:
Mid-Range
Low/Mid-Range
Mid-Range
Mid/High-Range
Low/Mid-Range
2
1
S
Face the helmet in the di-
rection of use, exposing it
to the surrounding light
conditions.
S
Press sensitivity More
button until the lens dark-
ens, then press Less
button until lens clears. An
alternative method is to
press and hold the Less
button until
the
clears.
Helmet is ready for use.
Slight readjustment may
be necessary for certain
applications or if lens is
flashing on and off.
.
Reduce Sensitivity set-
ting if lens stays dark
longer than Delay setting.
OM-256476 Page 11
lens