Diamond 350/GXS Kullanım ve Bakım Kılavuzu - Sayfa 12

Ticari Gıda Ekipmanları Diamond 350/GXS için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Diamond 350/GXS 16 sayfaları. Professional slicer ce

Sayfayı Yazdır

Diamond 350/GXS Kullanım ve Bakım Kılavuzu

5.2 - LOADING AND CUTTING THE PRODUCT

WARNING: The goods to be cut are loaded on the plate only with the graduated

handgrip at "0" and the motor stopped, being careful with the blade and the

points.

Adhere to the following procedure:

1. Lift the goods presser, load the go-

ods on the plate, bringing it close to

the thickness gauge, block it with

the proper toothed arm;

2. regulate the desired thickness of the

cut with the graduated handgrip;

3. assume a correct position to avoid

accident: place the right hand on the

goods presser handgrip and, then

the left hand next to the slice guard

to take the cut product (without tou-

ching the blade); the body must be

perpendicular to the work plane (Fig.

n°39).

WARNING: Do

not

assume

positions which bring body parts

in direct contact with the blade

(ex. Fig. n°40);

4. then push the "ON" push-button;

5. push the carriage (plate + goods

presser arm + stem) gently towards

the blade, without applying excessi-

ve pressure on the product with the

goods presser arm. The goods will

easily enter the blade, and the slice

guided by the proper sliceguard will

detach and fall on the plane (Fig. n°

40);

6. avoid running the slicer when

empty ;

7. at the end of the cutting operation,

stop the machine by putting the

switch in the "OFF" position and put

the graduated handgrip at "0";

8. Carry out resharpening the blade as

soon as the cut product has a threa-

ded or rough surface, therefore the

Fig. n°39

Fig. n°40

Fig. n°41

cutting effort increases (chapter 5.3).

5.3 -

SHARPENING THE BLADE

WARNING: Before starting to sharpen the blade, pay attention to RESI-

DUAL RISKS (chapter 4.2.2) concerning the dangers of cutting without ha-

ving followed the instructions listed below.

To sharpen the blade, which needs to be done periodically as soon a decrease

in cutting is noticed, the following directions must be adhered to:

1. disinsert the plug from the outlet and

carefully clean the blade with

denatured alcohol so it is degreased;

2. lift (a) the sharpener (1) and turn it

180° (b Fig. n°43);

3. let it go in a way that the sharpener

43);

4. check also that the blade stays be-

tween the two grinders;

5. insert the pin and start the machine,

by pressing the "ON" push-button;

6. press the push-button (2 Fig.n°44),

let the blade rotate in contact with the

grinder for about 30/40 sec. so that a

slight burr forms on the blade edge;

7. press the 2 push-buttons (2 and 3)

contemporaneously for 3/4 sec. and

release them in the same instant

(Fig. n°45);

8. after having completed the sharpe-

ning it is advisable to clean the grin-

Fig. n°42

Fig. n°43

Fig. n°44