AQUAPHOR RO-31 Kullanıcı El Kitabı - Sayfa 9

Su Filtrasyon Sistemleri AQUAPHOR RO-31 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AQUAPHOR RO-31 12 sayfaları. Drinking water machine
Ayrıca AQUAPHOR RO-31 için: Kullanım Kılavuzu (17 sayfalar)

Sayfayı Yazdır

• Insert the tip into the hole of the shutoff (fig. 14a), holding it over the sink.

• Holding the tip with your hand, put the shutoff into the sink, then drain the water from the water purifier

for 20–30 minutes.

• Disconnect the tip from the shutoff by pressing the button located on the shutoff end (fig. 14b).

• Close the inlet tap.

• Place the modules in the "for operation" position (see pig. 9 "Position of the modules in the RO").

• Open the inlet tap and make sure the RO is tight.

To replace the K0-100S replacement module:

• Close the inlet tap and connect the nozzle to the storage tank to relieve the pressure.

• Pressing the lock button fully in this position, turn the used filter module clockwise and remove it.

• Remove the packaging film from the new module.

• Insert the assembled module into the collector block until it stops and, while slightly pressing, turn the

module clockwise until it clicks.

• Open the inlet tap.

• Insert the tip into the hole of the shutoff (fig. 14a), holding it over the sink

• While holding the tip with your hand, put the shutoff into the sink, then drain the water from the water

purifier for 1 hour.

• Disconnect the tip from the shutoff by pressing

the button located on the shutoff end

(fig. 14b).

• Make sure the RO is sealed.

Conditioning cartridge replacement:

• Close the inlet tap and connect the storage

tank tip to relieve the pressure.

• Disconnect the JG tube from the outlet nipple.

To do this, remove the retaining clip from

under the plastic bushing, press down on the

end of the plastic bushing and pull out the

tube.

• Disconnect the blue JG tube from the inlet

fitting. To do this, remove the retaining clip

from under the plastic bushing, press down on

the end of the plastic bushing and pull out the

tube.

• Remove the conditioning cartridge from the

bracket. To do this, grab the module and pull

it towards you.

• To install a new conditioning cartridge, follow

the same steps in reverse order. Before

installing the module, do not forget to remove

the transport plugs (see paragraph "Installing

the conditioning cartridge").

• Open the inlet tap and make sure the RO

connections are tight.

• Fill and drain the storage tank once.

After replacing the conditioning

cartridge:

Fill and drain the storage tank once.

Figure 12a

Figure 13a

Figure 14a

Figure 12b

Figure 13b

Figure 14b