Burmester 032 Kullanıcı El Kitabı - Sayfa 11
Amplifikatör Burmester 032 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Burmester 032 16 sayfaları. Integrated amplifier
Sayfayı Yazdır
The setup menu allows the easy programming of certain basic settings of the integrated amplifier 032.
Press the button SETUP (11) on the front panel or press the MENU button on the remote
Activating setup
control.
The different items of the setup menu are selected in the sequence specified below by
Select menu item
repeatedly pressing the SETUP or MENU button.
The activated menu item is indicated on the left side of the display (3).
To change the setting of an activated menu item, rotate the VOLUME knob (8) to the left to
Change settings
lower the set value or to the right to increase it. To change the settings you can also use the
VOLUME buttons on the remote control.
The selected value of the menu item is indicated on the right side of the display (3).
The setup menu is closed automatically after 10 seconds, when no adjustment has been
Deactivating setup
made.
The following table lists all items that can be adjusted using the setup menu. The factory
Menu items
default settings have been underlined.
MENU ITEM
Input level CD
Input level TUNER
Input level TAPE
Input level AUX1
Input level AUX2
Volume
Output amplification
The input level adjustment feature serves to avoid big jumps in volume, when switching
Input level
between signal sources with different output levels.
This menu item allows you to preset the volume level, when the 032 is switched on. The
Volume
setting L represents LAST, which means that when you switch on the 032, it starts at the
same volume level it was last playing before it was switched off. The maximum value is
limited to 30.
To achieve the best match with your loudspeakers, the output level of the amplification
Output amplification
stages may be adjusted. HI stands for high amplification, LO accordingly for low
amplification. When switching between these settings, the speaker relays are briefly
switched off to avoid malfunctioning.
THE SETUP MENU
DESCRIPTION
Input level adjustment for input CD
Input level adjustment for input TUNER
Input level adjustment for input TAPE
Input level adjustment for input AUX1
Input level adjustment for input AUX2
Selecting initial volume (L=Last volume)
Power amplification high (HI) or low (LO)
DISPLAY
L-CD
7
VALUE
-9 bis 0 bis +9
-9 bis 0 bis +9
L-TU
-9 bis 0 bis +9
L-TP
-9 bis 0 bis +9
L-A1
-9 bis 0 bis +9
L-A2
0 bis 5, 10, 15, 20, L
VOL
PA
HI / LO