Burmester 032 Kullanıcı El Kitabı - Sayfa 13
Amplifikatör Burmester 032 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Burmester 032 16 sayfaları. Integrated amplifier
Sayfayı Yazdır
Connecting to the BURLINK interface can be done either with the 9 pin D-SUB connector (RS-232) or with the USB
2.0 connector.
RS-232 configuration: 9600Baud, 8bit, parity: none, 1 stop bit, no hardware handshake
A USB device driver needs to be installed when using the USB 2.0 connector. System requirements for using the
USB software are either WINDOWS 2000 or WINDOWS XP operating system.
Following are listed the possible commands to control the integrated amplifier 032. All commands needs to be sent
in capital letters finished with a "carriage return" \r .
POWON\r
POWOFF\r
CD\r
TUNER\r
AUX\r
AUX1\r
AUX2\r
TAPE\r
SURR\r
VOLUP\r
VOLDN\r
MONITOR\r
MONITORON\r
MONITOROFF\r
TONE\r
TONEON\r
TONEOFF\r
BASSUP\r
BASSDN\r
TREBLEUP\r
TREBLEDN\r
BALANCEL\r
BALANCER\r
DIM0\r
DIM1\r
DIM2\r
DIM3\r
DIM\r
TYPE\r
VERSION\r
BURLINK
CONNECTIONS
COMMANDS
switches the unit on
switches the unit to standby mode
activates the CD input
activates the TUNER input
changes between inputs AUX1 and AUX2
activates the AUX1 input
activates the AUX2 input
activates the TAPE input
activates the SURROUND input
increases the volume for one step
decreases the volume for one step
switches the monitor loop on or off
switches the monitor loop on
switches the monitor loop off
switches the tone control on or off
switches the tone control on
switches the tone control off
increases the bass volume for one step (2dB)
decreases the bass volume for one step (2dB)
increases the treble volume for one step (2dB)
decreases the treble volume for one step (2dB)
lowers the volume of the right channel for one step (1dB)
lowers the volume of the left channel for one step (1dB)
switches the display brightness to maximum
switches the display brightness to middle
switches the display brightness to low
switches the display to off mode
switches the brightness step by step (0,1,2,3,0,1,2....)
shows the type of the unit
shows the software version of the unit
9