Aquasana AQ-SFRO Kullanıcı El Kitabı - Sayfa 6

Su Filtrasyon Sistemleri Aquasana AQ-SFRO için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Aquasana AQ-SFRO 13 sayfaları. Under sink water filter smartflow reverse osmosis

Sayfayı Yazdır

INSTALLATION STEPS

Connect Tubing

NOTES: Insert tubing completely to ensure connection. A fully connected tube can be

inserted up to 5/8 an inch.

Wet end of tubing for easier insertion.

Connect tubing to system in a way that does not bend, crimp, or kink tubing as this will

affect system performance. If tubing is too long, measure and cut to necessary length.

If cutting the tubing due to excess length, cut the tubing straight across, not at an angle.

Faucet Connect

A. Connect the pre-installed 1/4" red tubing (smaller tubing) on the faucet to

the system manifold. Push red tubing into the red inlet port

on the back of the system manifold, labeled, 'waste'.

B. Connect open end of the pre-installed 1/4" blue tubing coming from the

faucet into the bottom end of remineralizer port.

C. Locate the blue tubing piece included in the installation kit and connect

to the top port of the remineralizer. Connect open end of blue tubing

coming from the remineralizer into the blue inlet port on the back of the

system manifold labeled, 'pure'.

D. Connect the pre-installed 3/8" red tubing (larger tubing) on the faucet to

the open port of the drain saddle. Do not allow the tubing to dip below

the drain saddle.

Inlet Tee Valve Connect

A. Locate the white tubing connected to the inlet tee valve. Using a utility knife

or scissors, cut the white tubing to the length needed to reach the back of

the system manifold.

B. Push white tubing into white inlet port on the

back of the system manifold, labeled, 'inlet'.

HOT

INSTALLATION STEPS

COLD