Aquasana AQ-5300 Kurulum Talimatları - Sayfa 3

Su Sebili Aquasana AQ-5300 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Aquasana AQ-5300 5 sayfaları. Under counter water filter
Ayrıca Aquasana AQ-5300 için: Kurulum Talimatları Kılavuzu (8 sayfalar)

Sayfayı Yazdır

Easy to install

1. Unpack and unwrap contents. Turn off and

disconnect the cold water supply.

3. Attach white tube to the brass tee: Slide the compression nut

onto the white tubing (with threads of the nut facing the end of

the white tube). Next, slide the plastic sleeve onto the white tube.

Place brass insert into the opening of white tube. Push the tip of the

white tubing into the opening of the brass tee.While holding the

white tube in place inside the brass tee, tighten the compression

nut to compress the plastic sleeve and create a seal. NOTE: Use a

wrench to ensure complete seal. Avoid over tightening.

4. Unit installation: Select a space under your

sink for the filter unit that is at least 12 inches

from the bottom of your cabinet and allows

for easy access to your cold water supply and

for filter replacements. Use a pencil to mark

wall screw placements.

2. Brass Tee Installation: Attach threaded

ends of supplied brass tee to the cold water

supply line and shut-off valve; tighten using an

adjustable wrench.

5. Mount unit to the wall with the screws and

plastic anchors provided. Pull the protective

plastic strip from the battery compartment.

The red LED should flash and beep five (5)

times to indicate that the battery is installed

correctly.

6. Faucet Installation:

Install as shown.

Tighten nut to secure

faucet to sink.

8. Connect the supply lines: push the tubing

into the inlet side and outlet side of the

housing. The tee fitting tube goes to the inlet

and the faucet tube goes to the outlet.

7. Faucet Connection: connect the outlet hose to the

base of the faucet by sliding the chrome nut onto

the tube followed by the white collar. Place the white

insert into the end of the tube. Press the tube against

the faucet base and slide the nut and collar up to the

threads. Use wrench to ensure seal is sufficiently tight.

Note: Avoid over tightening.

9. Turn the cold water on. Check for leaks and

proper installation: place a towel under the

filter unit and check for leaks. Allow water to

run for 10 minutes to flush carbon fines.

Note: Never use oils to lubricate the O-rings;

O-rings come pre-lubricated.

Enjoy your filtered water!