AQUASOL AM-P-AL Kullanıcı Kılavuzu - Sayfa 6

Ölçüm Cihazları AQUASOL AM-P-AL için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AQUASOL AM-P-AL 8 sayfaları. Multi parameter handheld meter

Sayfayı Yazdır

Make sure the sensor is 3-in-1 electrode and switch to

pH mode.

Dip the electrode into the buffer solution 1413 ìS/cm

(706 PPM). Stir gently and wait until the reading is

stable. Press and hold "CAL" for 5 sec. to enter

calibration mode. The display will appear CAL and

flashing 1413 ìS/cm (706 PPM). When the display stops

flashing calibration ends, and meter will return to

measurement mode.

Note:

Calibration error indicator icon will appear, and "Err" if

calibration fails.

Measurement:

<pH>

Press "MODE" to choose pH mode.

After calibration, rinse the 3-in-1 electrode with clean

water and wipe it dry. Dip the electrode into the sample

solution which is going to be measured. Stir gently and

wait until a stable reading can be obtained.