AQUASOL AM-P-AL Kullanıcı Kılavuzu - Sayfa 7

Ölçüm Cihazları AQUASOL AM-P-AL için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AQUASOL AM-P-AL 8 sayfaları. Multi parameter handheld meter

Sayfayı Yazdır
AQUASOL AM-P-AL Kullanıcı Kılavuzu
<COND, TDS, Salt>
Press "MODE" to choose COND, TDS or Salt mode.
After calibration, rinse the 3-in-1 electrode with clean
water and wipe it dry. Dip the electrode into the sample
solution which is going to be measured. Stir gently and
wait until a stable reading can be obtained.
Battery Change :
1. If battery is low, meter will flash low indication.
2. Open the battery case, take out the old battery and
replace with new one (3Nos x LR44) cells.
3. Please mind the polarity of the batteries when install
them into the meter.
Electrode Replacement :
1. Unscrew the electrode collar and remove it.
2. Remove the electrode module from the meter.
3. Plug the new electrode module in the meter socket
carefully.
4. Replace the collar and tighten the electrode to make
good seal.