Panasonic aw-he40 series Hızlı Başlangıç Kılavuzu
Dijital Kamera Panasonic aw-he40 series için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Panasonic aw-he40 series 2 sayfaları. Adding another camera to existing system
Ayrıca Panasonic aw-he40 series için: Kurulum ve Ayarlama Kılavuzu (12 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Manuel (4 sayfalar)
Sayfayı Yazdır
Adding Another AW-HE40 Camera to Existing System
★ This is to explain the procedure for adding another AW-HE40 camera as CAM4 to an existing system that consists
of three AW-HE40 cameras and one AW-RP50 controller.
1.
Connect AW-HE40 LAN port and the hub using a LAN cable. (AW-HE40 can automatically recognize whether
it is a cross or straight cable.)
* LAN Cable: Category 5 or higher, Up to 100m (Category 5e or higher if connected via a PoE+ compatible hub)
2.
By [1] CAMERA CTL setting, select [No Asign] for the CAMERA No. you want to add.
① Press MENU button. - (Fig. 1-A)
② Press [10] SYSTEM button. - (Fig. 1-B)
* If it is not displayed, turn F1 dial to make "[1] CAMERA CTL" appear.
③ While "[1] CAMERA CTL" is displayed on the LCD screen, press F1 dial. - (Fig. 1-C)
④ Turn F1 dial to make [CAM4] appear. - (Fig. 2)
⑤ Turn F2 dial to select [No Asign], then press F2 dial to determine the setting. - (Fig. 1-D)
（A）
* "[1] CAMERA CTL" will be displayed on the LCD screen. - (Fig. 2)
(Figure 1)
(Figure 2)
MENU ON ⇒ Select [10]
［1］CAMERA CTL
Press F1
（C）
1. CAM1
（D）
（B）
2. CAM2
3. CAM3
Installed & Set Already
Turn F1
4. CAM4
Turn F2 ⇒ Select "No Asign" ⇒ Press F2 to determine
Network
Network
Network
No Asign