AQUATECH REFLEX Kullanım Kılavuzu - Sayfa 6

Kamera Aksesuarları AQUATECH REFLEX için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AQUATECH REFLEX 9 sayfaları. Sport housing
Ayrıca AQUATECH REFLEX için: Kullanım Kılavuzu (5 sayfalar)

Sayfayı Yazdır

Zoom Gear Control

Located on the front left of our Sport Housing, this

control drive gear engages our Zoom Gear to change

the focal length of the lens, where applicable.

Lens Port

Before installing your Lens Port make sure the O Ring

is present. Then place your port inside the front Sport

Housing and turn clockwise until its secure. Remember

to seal your Lens Port very tight with both hands to

ensure a good seal on the front O-Ring between your

Lens Port and Sport Housing.

Securing the Housing

When you first receive your gear we recommend that

you do these steps without the camera and lens inside

the Sport Housing:

1. Open your Backplate and remove the port. Ensure

O-Rings and Seals are present and in the assigned

grooves.

2. Attach the Camera Plate to the bottom of your

camera and slide it into the Sport Housings Manny

Mount.

3. With the Sport Housing facing downward put the

Backplate on following the same steps detailed in the

Initial Setup.

4. Once the buttons are positioned over the cameras'

controls correctly you can then clamp down the two

safety clips, making sure the two clips are firmly locked

and your Backplate is secure.

5. Check the Main Seal to ensure that you have a nice

seal all around and that the Main Seal is not pinched.

6. When your Backplate is securely fastened, your

safety clips should be parallel with the Safety Clip

Protector. The important final check with the clip is to

pull up against it to make sure it does not come undone

and is locked. When the safety clip is locked the clip will

not release,

7. Screw your Lens Port onto the Sport Housing. Your

Port should screw on with ease and never feel as if it

is being forced. Ensure the thread on the base of your

Port and the Front of the Sport Housing are aligned.

Tighten the port clockwise making sure not to pinch the

Compression O-Ring. Before every use please repeat

these steps to make sure your Sport Housing has a

watertight seal.

Water testing

Water testing is a very important process before

entering the water in all types of conditions. Once you

have followed "Securing the Sport Housing" instructions

we recommend that you perform a water test yourself

without the camera and lens inside.

1. Fill up a bathtub, use a swimming pool or hop in the

ocean to test. The choice is yours just as long as you

have a body of water where you can fully submerge

your equipment.

2. Hold your equipment under the water for 5-10

seconds while also pressing all the buttons. Then hold

the Sport Housing above your head at a tilted angle

so that if there is any water inside it will gather at the

bottom right back corner.