Diamond Systems JUPITER-MM-SIO Kullanıcı Kılavuzu - Sayfa 12

Güç Kaynağı Diamond Systems JUPITER-MM-SIO için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Diamond Systems JUPITER-MM-SIO 14 sayfaları. Dc/dc power supply pc/104 module with 2 rs-232/422/485 serial ports

Sayfayı Yazdır

5. INSTALLATION

All Jupiter-MM-SIO power supplies are load tested prior to shipping. The supplies ship with all the external

connectors required to start using your supply immediately. Any connector not needed can be removed.

1. Select the serial port base addresses using J9. Refer to page 9 for instructions.

2. Select the serial protocol for each serial port using J7 and J8.

3. Select the interrupt levels desired for each serial port using J10 and J11.

4. Connect a DC source to the Main power connector J4, or to the Auxiliary connector J5. The supply will

operate with input voltages from 7 to 30VDC.

CAUTION: VOLTAGES ABOVE 31V WILL BE SHUNTED TO GROUND THROUGH THE TRANSIENT

VOLTAGE SUPRESSOR (TVS). THE TVS IS RATED FOR 1,500 WATT SURGES, BUT IT MAY BE

DAMAGED BY SUSTAINED VOLTAGES ABOVE 31V.

5. Once the input voltage is in the valid range, verify that the power output indicator LEDs in the lower left

corner are illuminated. This verifies your input power connections and the supply are fully functional.

Note that only indicators corresponding to the voltages available on the supply will be lit. On the dual

output version, the –5V and –12V LEDs may be present on the board but will not be lit.

6. Power down the supply. Plug the supply into your PC/104 stack. Your system is ready to use.

Jupiter-MM-SIO User Manual V1.3

p. 12