Panasonic P1SDU - SVGA LCD Projector Kullanım Talimatları Kılavuzu - Sayfa 15
Projektör Panasonic P1SDU - SVGA LCD Projector için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic P1SDU - SVGA LCD Projector 42 sayfaları. Lcd projector commercial use
Sayfayı Yazdır
Turning off the power
#
$
POWER button
,
%
Power cord
#
Press the POWER button.
BThe "POWER OFF" confirmation screen
will be displayed.
Press the POWER button again.
$
BThe lamp unit will switch off and the picture will stop being projected.
(The POWER button on the projector will illuminate orange while the
cooling fan is still operating.)
NOTE:
BPress any button other than the POWER button to cancel the "POWER
OFF" screen.
BThe "POWER OFF" screen will disappear in five seconds.
%
Disconnect the power cord after the POWER
button on the projector illuminates red.
NOTE:
B You can also turn off the power by holding down the POWER button for
at least 0.5 seconds.
28-E
NGLISH
POWER
INPUT
MENU
ENTER
AUTO
SETUP
STD
SHUTTER
RETURN
VOLUME
ENTER
ROTATE
P O W E R O F F
[ P O W E R ] O K
Direct power off function
You can disconnect the power cord during projection or immediately after
use and move the projector. The cooling fan will operate by the internal
power supply to cool down the lamp.
B When this function is used, it may take more time for the lamp to turn back
on again compared to when the lamp cools down with the power cord
connected.
B Do not put the projector in the softcase while the POWER button on the
projector is illuminated.
NOTE:
B Do not disconnect the power cord while the files in the SD memory card
are being played back.
CAUTION
If not using the projector for an extended period of time, disconnect the
power cord plug from the wall outlet.
B If dust builds up on the power cord plug, the resulting humidity may
damage the insulation, which could result in fire.
B This projector continues to draw approximately 3 W of power even when
the power is turned off.
POWER button on the projector
POWER button status
The projector is in standby mode and image projection
Red
Illuminated
is possible by pressing the POWER button.
The projector is preparing for projection after the
power has been turned on while the POWER button
Flashing
on the projector is illuminated red. (After a short
Green
period, a picture will be projected.)
Illuminated
A picture is being projected.
The lamp is cooling down after the power has been
Illuminated
turned off or while direct power off function is
operating.
Orange
The projector is preparing for projection after the
power has been turned on while the POWER button
Flashing
on the projector is illuminated orange. (After a short
period, a picture will be projected.)
Projector status
E
-29
NGLISH