Diamond Vantage TS400 Kullanıcı El Kitabı - Sayfa 14

Testere Diamond Vantage TS400 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Diamond Vantage TS400 20 sayfaları.

Sayfayı Yazdır

WARNING!

For your safety and the safety of others, turn the power switch off and always remove the plug from the power

source before troubleshooting. Repairs performed by unauthorized personnel could cause serious hazard. We

recommend that service to this tool be performed by a qualified service technician with original equipment

replacement parts.

EXCESSIVE NOISE. If excessive noise is emanating from

the gearbox, have the tool serviced.

BLADE WILL NOT CUT. Check for worn out diamond edge.

Be sure that the arrow on the blade is rotating in the

same direction as the motor arbor and/or the arrow on

the blade guard. Make sure the blade is suitable for the

material to be cut. The blade might have become dull if

it has been used to cut a hard material. Dress the blade

by cutting a lightweight abrasive block to expose fresh

diamonds.

MOTOR WILL NOT START. Check power supply. If the

water pump turns on when the power switch is in the

"on" position, but the motor does not, have the motor

serviced.

MOTOR WILL NOT STOP. The contacts in the switch may

have become arched together in the "on" position – have

the tool serviced.

MOTOR SHUTS OFF DURING OPERATION. Check to see

that the circuit you are using is not overloaded with

lights or other equipment. The fuse or circuit breaker

may not have sufficient capacity – use 20-amp power.

If you are using an extension cord, check the extension

cord table to make sure it is heavy enough to carry the

current this product will draw. See Page 13 for electric

cord reference.

EXCESSIVE VIBRATION. Check to see that the blade is

mounted properly according to safe operating practices

section. Try a different blade as the blade might be out of

balance. The arbor shaft bearings might be worn and, in

that case, have the tool serviced.

XI. TS400: TROUBLESHOOTING

• 14 • diamondvantage.com

NOT CUTTING SQUARE. Check the main table and

carriage adjustment as well as the blade alignment

procedure.

MAIN TABLE DOES NOT MOVE FREELY. Inspect the guide

rails and rollers for build up of tile chips or dry slurry

deposits. Clean and check guide roll or adjustments.

NO WATER FLOW TO BLADE. Check the water feed

tube for kinks or obstructions. Check the inlet screen

to ensure it is not clogged. Remove the pump inlet and

turn the impeller to ensure it is not damaged or jammed.

Clean the impeller if necessary and apply a drop of light

oil to the shaft - be sure the impeller spins freely.

POOR MACHINE PERFORMANCE WITH LITTLE POWER.

Check cord/extension cable for appropriate length and

gage. Check power network for sufficient power and

circuit breaker capacity.

CENTER HOLE IN BLADE OVERSIZE OR WORN. Saw blade

has slipped on shaft while running. Check shaft for

damage and replace blade.