Panasonic SA-PMX3 Kullanım Talimatları Kılavuzu - Sayfa 16
Stereo sistemi Panasonic SA-PMX3 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic SA-PMX3 18 sayfaları. Cd stereo system model no. sc-pmx3
Sayfayı Yazdır
Troubleshooting guide
Before requesting service, make the below checks. If you can't fi x the system as described below, or if something not listed here occurs, refer
to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
Playing back
No sound.
Sounds unfi xed, reversed or come from
one speaker only.
Humming heard during play.
The display is wrong or play
won't start.
Radio
Noise is heard.
The stereo indicator fl ickers or doesn't
light.
Sound is distorted.
A beat sound is heard.
A low hum is heard during AM
broadcast.
USB
The USB drive or its contents cannot
be read.
Slow operation of the USB fl ash drive.
USB recording stops suddenly.
"REC ERROR" is displayed.
Others
The picture on the TV
disappears or stripes appear
on the screen.
Remote control doesn't work.
Unit displays
"NO PLAY"
"USB OVER CURRENT ERROR"
"F61"
"F76"
"ERROR"
"VBR–"
"- -:- -"
"MP3 ERROR" or "PLAYERROR"
"UNSUPPORT"
16
"HI-SPEED CAN'T REC"
16
PMX3_E_EN.indd 16
PMX3_E_EN.indd 16
Turn the volume up.
The speaker cords may not be connected properly. Turn the unit off, check and correct the
connections and turn the unit on ( ➡ page 4).
Check the speaker connections ( ➡ page 4).
An AC mains lead or fl uorescent light is near the cables. Keep other appliances and leads
away from this unit's cables.
If possible in your area, turn the AC mains lead's plug or connector over to reverse the lead's
polarity.
The disc may be upside down ( ➡ page 7).
Wipe the disc.
Replace the disc if it is scratched, warped, or non-standard.
Condensation may have formed inside the unit due to a sudden change in temperature. Wait
about an hour for it to clear and try again.
Use an outdoor antenna ( ➡ page 5).
Turn the TV off or separate it from the unit.
Separate the antenna from other cables and cords.
The USB drive format or its contents is/are not compatible with the system, "NO PLAY" is
displayed. Unplug the USB device and insert it again ( ➡ page 11).
Alternatively, format the USB device and record the desired tracks again and playback the
device ( ➡ page 13).
The USB host function of this product may not work with some USB devices.
USB devices with storage capacity of more than 8 gigabytes may not work in some
instances.
Large fi le size numerous fi les or high memory USB fl ash drive takes longer time to read.
Select a suitable recording mode (128 KBPS or 192 KBPS) and resume recording.
The location and direction of the antenna are incorrect. If you are using an indoor antenna,
change to an outdoor antenna ( ➡ page 5).
The TV antenna wire is too close to the unit. Separate the antenna wire of the TV set from
the unit.
Check that the batteries are inserted correctly ( ➡ page 5).
Replace the batteries if they are worn.
Check the content.
Only MP3 format fi les can be played.
The USB mass storage device rating exceeds 500mA. Disconnect the USB device. Turn the
unit off and then back on.
Check and correct the speaker cable connections.
If this does not fi x the problem, consult the dealer.
There is a power supply problem. Consult the dealer.
Incorrect operation performed. Read the instructions and try again.
The unit cannot display the remaining play time for variable bit rate (VBR) tracks.
You plugged the AC mains lead in for the fi rst time or there was a power failure recently.
Set the time ( ➡ page 9).
You have played an unsupported format.
Check the contents.
You have inserted an unsupported device ( ➡ page 11).
You cannot use high-speed recording while using analogue mode. Change to digital mode or
use normal recording.
6/17/08 10:15:36 AM
6/17/08 10:15:36 AM