Dickinson NEWPORT Kurulum ve Kullanım Kılavuzu - Sayfa 4

Yüzme Havuzu Isıtıcısı Dickinson NEWPORT için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Dickinson NEWPORT 10 sayfaları. Diesel heater
Ayrıca Dickinson NEWPORT için: Kullanım ve Kurulum Talimat Kılavuzu (16 sayfalar), Kullanım Talimatları Kılavuzu (19 sayfalar)

Sayfayı Yazdır

INSTALLATION

LOCATION

The Newport solid fuel should be mounted on a bulkhead. The area available must be large enough to

allow at least 8" of side clearance from combustible surfaces. It must be lined with high-density heat

retardant insulation and finished with a light gauge metal preferably stainless steel. Locate the heater

as close to the floor as possible for maximum stack length and to provide good heat convection. The

location must also take into consideration stack configuration and insure that the chimney above deck

is clear of any obstruction.

MOUNTING AND SECURING

Screw or bolt the heater to the stainless steel panel on the bulkhead using the rear mounting brackets

provided.

FLUE STACK

The length and straightness of the flue stack are important to the efficient burning of the heater.

Diameter

3" (7.82cm)

Recommended length -

3 to 4 ft (.91 to 1.21m)

Note

The stack must be the correct diameter.

The flue pipe requires 1" (25mm) of clearance as it rises through the deck.

Elbows in excess of 45 degrees not recommended.

A barometric damper is highly recommended to slow the burning but keep the

draft strong. A manual flue damper is also available but is only recommended when installed in a very

short chimney length otherwise a barometric damper is the best.

THE ROUND PIPE IS SQUEEZED TO FIT THE OVAL FLUE COLLAR ON THE HEATER