Olympus BondMaster 600 Başlangıç Kılavuzu - Sayfa 4
Dijital Kamera Olympus BondMaster 600 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Olympus BondMaster 600 12 sayfaları. Composite bond tester
Ayrıca Olympus BondMaster 600 için: Hızlı Başlangıç Kılavuzu (1 sayfalar), Hızlı Başlangıç Kılavuzu (1 sayfalar), Teknik Özellikler (2 sayfalar)
Sayfayı Yazdır
To Replace the Lithium-Ion Battery
1.
Unfold the instrument stand.
2.
On the back of the instrument, loosen the two
thumb screws securing the battery
compartment cover.
3.
Remove the battery compartment cover.
4.
Disconnect and remove the battery.
5.
Install a new battery (P/N: 600-BAT-L-3
[U8051431]) into the battery compartment.
6.
Reinstall the battery compartment cover on
the back of the instrument, and tighten the
two thumb screws to complete the
installation.
To Install the MicroSD Card
1.
Remove the MicroSD card (P/N: MICROSD-ADP-2GB [U8779307]) from its packaging.
2.
Loosen the two thumb screws, and then open
the BondMaster 600 I/O door
3.
Hold the card so that the MicroSD card label
faces toward the rear of the instrument.
4.
Gently slide the card into the MicroSD slot
until it clicks.
NOTE
To remove the MicroSD card, gently push the card into the instrument and release. A spring-loaded
mechanism will partially eject the card, and then you can grasp and remove it from the instrument.
4
Lithium-ion battery
MicroSD
card slot
MicroSD
card
BondMaster 600 — Getting Started Guide
Stand
Battery
compartment cover