Olympus BondMaster 600 Посібник для початківців - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник для початківців для Цифрова камера Olympus BondMaster 600. Olympus BondMaster 600 12 сторінок. Composite bond tester
Також для Olympus BondMaster 600: Посібник із швидкого старту (1 сторінок), Посібник із швидкого старту (1 сторінок), Технічні характеристики (2 сторінок)
To Replace the Lithium-Ion Battery
1.
Unfold the instrument stand.
2.
On the back of the instrument, loosen the two
thumb screws securing the battery
compartment cover.
3.
Remove the battery compartment cover.
4.
Disconnect and remove the battery.
5.
Install a new battery (P/N: 600-BAT-L-3
[U8051431]) into the battery compartment.
6.
Reinstall the battery compartment cover on
the back of the instrument, and tighten the
two thumb screws to complete the
installation.
To Install the MicroSD Card
1.
Remove the MicroSD card (P/N: MICROSD-ADP-2GB [U8779307]) from its packaging.
2.
Loosen the two thumb screws, and then open
the BondMaster 600 I/O door
3.
Hold the card so that the MicroSD card label
faces toward the rear of the instrument.
4.
Gently slide the card into the MicroSD slot
until it clicks.
NOTE
To remove the MicroSD card, gently push the card into the instrument and release. A spring-loaded
mechanism will partially eject the card, and then you can grasp and remove it from the instrument.
4
Lithium-ion battery
MicroSD
card slot
MicroSD
card
BondMaster 600 — Getting Started Guide
Stand
Battery
compartment cover