Olympus BH2 Series Komple Söküm, Temizlik ve Yeniden Montaj - Sayfa 18

Mikroskop Olympus BH2 Series için çevrimiçi göz atın veya pdf Komple Söküm, Temizlik ve Yeniden Montaj indirin. Olympus BH2 Series 23 sayfaları. Phase contrast
Ayrıca Olympus BH2 Series için: Sorun Giderme ve Ayarlama Kılavuzu (46 sayfalar), Komple Söküm, Temizlik ve Yeniden Montaj (40 sayfalar), Söküm, Temizlik ve Yeniden Montaj (45 sayfalar), Manuel (6 sayfalar), Kurulum Kılavuzu (9 sayfalar)

Reinstall the Arm onto the Base

Place the arm flat on its back on the work surface with

the bottom facing you (see Figure 55).

Figure 55 – Place the arm flat on the work surface

Hold the base of the stand in position such that the four

holes in the base align with the four tapped holes in the

bottom surface of the arm casting (see Figure 56).

Figure 56 – Align holes in the base with holes in the arm

Use a 5mm Allen wrench or driver to loosely reinstall

four M6x25 hex, socket‐head cap screws to attach the

arm to the base of the stand (see Figure 57).

Figure 57 – Attach the base onto the arm of the stand

Complete Teardown, Cleaning, and Reassembly of the Olympus BH‐2 Sliding Focus Block

Check the alignment of the arm (relative to the base)

and adjust the positioning as necessary for an

acceptable cosmetic appearance at the interface.

Tighten the four M6x25 screws to secure the arm to the

base (see Figure 58).

Figure 58 – Secure the arm onto the base of the stand

Reinstall the Electrical Base

Carefully lower the assembled stand over the electrical

base, maintaining proper alignment relative to the

electrical base (to prevent damage to the optical

components in the base) until the stand seats onto the

base. If the electrical base contains a light‐preset

control/switch (see

into the notch in the side of the base

the stand onto the electrical base. While holding the

electrical base in place so that it does not shift, lay the

stand onto its back or side on the work surface. Use a

4mm (or 5/32") Allen wrench or driver to reinstall four

M5x12 hex, socket‐head cap screws and associated

washers to secure the electrical base to the stand (see

Figure

59). Return the assembled stand to its normal

upright position.

Figure 59 – Reinstall screws to secure the electrical base

Or reconnect the two electrical connectors to the printed circuit board.

Figure

5), be sure to reengage this

before seating

Revision 2

Page 18 of 23