Olympus BH2 Series Kurulum Kılavuzu

Mikroskop Olympus BH2 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Olympus BH2 Series 9 sayfaları. Phase contrast
Ayrıca Olympus BH2 Series için: Sorun Giderme ve Ayarlama Kılavuzu (46 sayfalar), Komple Söküm, Temizlik ve Yeniden Montaj (23 sayfalar), Komple Söküm, Temizlik ve Yeniden Montaj (40 sayfalar), Söküm, Temizlik ve Yeniden Montaj (45 sayfalar), Manuel (6 sayfalar)

2021/10/12 04:32

Olympus BH-2 Microscope Motor Drive

Installation

Motor Drive Installation

This procedure steps you through the installation and alignment of the ASI motor drive onto the

Olympus BH-2 microscope. The following tools are required for this procedure:

Small knife or screwdriver

2.5 mm Allen wrench ( Provided )

3.0 mm Allen wrench ( Provided )

1.5 mm Allen wrench ( Provided )

3/32 mm Allen wrench ( Provided )

5/64 mm Allen wrench ( Provided )

7/64 mm Allen wrench ( Provided )

9/64 mm Allen wrench ( Provided )

1/16 mm Allen wrench ( Provided )

Preparing The Microscope

In this part of the procedure the left ﬁne focus knob will be removed from the microscope:

Prior to removing left ﬁne focus knob, the microscope stage should be fully lowered. To do this,

release the lock by rotating fully counter-clockwise the lock ring behind the left coarse focus knob,

then rotate the coarse knob to lower the stage all the way down.

Applied Scientiﬁc Instrumentation - https://asiimaging.com/docs/

1/9

Note: the terms left and right refer to the sides of the

microscope as viewed from the front.

Olympus BH-2 Microscope Motor Drive Installation