Olympus BH2 Series Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Mikroskop Olympus BH2 Series. Olympus BH2 Series 9 stron. Phase contrast
Również dla Olympus BH2 Series: Instrukcja rozwiązywania problemów i regulacji (46 strony), Kompletny demontaż, czyszczenie i ponowny montaż (23 strony), Kompletny demontaż, czyszczenie i ponowny montaż (40 strony), Demontaż, czyszczenie i ponowny montaż (45 strony), Podręcznik (6 strony)

2021/10/12 04:32

Olympus BH-2 Microscope Motor Drive

Installation

Motor Drive Installation

This procedure steps you through the installation and alignment of the ASI motor drive onto the

Olympus BH-2 microscope. The following tools are required for this procedure:

Small knife or screwdriver

2.5 mm Allen wrench ( Provided )

3.0 mm Allen wrench ( Provided )

1.5 mm Allen wrench ( Provided )

3/32 mm Allen wrench ( Provided )

5/64 mm Allen wrench ( Provided )

7/64 mm Allen wrench ( Provided )

9/64 mm Allen wrench ( Provided )

1/16 mm Allen wrench ( Provided )

Preparing The Microscope

In this part of the procedure the left ﬁne focus knob will be removed from the microscope:

Prior to removing left ﬁne focus knob, the microscope stage should be fully lowered. To do this,

release the lock by rotating fully counter-clockwise the lock ring behind the left coarse focus knob,

then rotate the coarse knob to lower the stage all the way down.

Applied Scientiﬁc Instrumentation - https://asiimaging.com/docs/

1/9

Note: the terms left and right refer to the sides of the

microscope as viewed from the front.

Olympus BH-2 Microscope Motor Drive Installation