Olympus BH2-CH Substage Montaj - Sayfa 15
Mikroskop Olympus BH2-CH Substage için çevrimiçi göz atın veya pdf Montaj indirin. Olympus BH2-CH Substage 26 sayfaları.
Figure 46 – Lightly grease the underside of centering yoke
Place the back of the centering yoke against the
centering plunger, and while pressing on the centering
yoke to depress the centering plunger, seat the
centering yoke into the support yoke (see
Figure 47 – Reinstall centering yoke into support yoke
Reinstall the Slip Plates
Carefully reposition any small, brass shim washers back
into the original locations where they were found
during disassembly (see
Figure 48 – Reinstall any brass shim washers
Apply a thin layer of grease to the three slip bosses
machined into the support yoke (see
Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly
Figure
Figure
48).
Figure
49).
Figure 49 – Apply grease to the three slip bosses
Carefully place the three slip plates onto the greased
slip bosses, aligning the holes in the slip plates with the
tapped holes in the centering yoke, without disturbing
47).
any of the brass shim washers (see
Figure 50 – Reinstall slip plates onto the slip bosses
Use a suitable JIS screwdriver to reinstall six M2x4 JIS
screws to secure the slip plates onto the centering yoke
(see
Figure
Figure 51 – Reinstall screws to secure the slip plates
Figure
51).
Revision 1
50).
Page 15 of 26