Olympus BH2-CH Substage Montaggio - Pagina 15

Sfoglia online o scarica il pdf Montaggio per Microscope Olympus BH2-CH Substage. Olympus BH2-CH Substage 26.

Figure 46 – Lightly grease the underside of centering yoke

Place the back of the centering yoke against the

centering plunger, and while pressing on the centering

yoke to depress the centering plunger, seat the

centering yoke into the support yoke (see

Figure 47 – Reinstall centering yoke into support yoke

Reinstall the Slip Plates

Carefully reposition any small, brass shim washers back

into the original locations where they were found

during disassembly (see

Figure 48 – Reinstall any brass shim washers

Apply a thin layer of grease to the three slip bosses

machined into the support yoke (see

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

48).

Figure

49).

Figure 49 – Apply grease to the three slip bosses

Carefully place the three slip plates onto the greased

slip bosses, aligning the holes in the slip plates with the

tapped holes in the centering yoke, without disturbing

47).

any of the brass shim washers (see

Figure 50 – Reinstall slip plates onto the slip bosses

Use a suitable JIS screwdriver to reinstall six M2x4 JIS

screws to secure the slip plates onto the centering yoke

(see

Figure

Figure 51 – Reinstall screws to secure the slip plates

Figure

51).

Revision 1

50).

Page 15 of 26