Olympus BH2-CH Substage Montaggio - Pagina 17

Sfoglia online o scarica il pdf Montaggio per Microscope Olympus BH2-CH Substage. Olympus BH2-CH Substage 26.

Figure 58 – Reinstall the plastic friction lock in bore

Use a 3.0mm Allen wrench or driver to loosely reinstall

the M4x12 hex socket-head cap screw to secure the

plastic friction lock into the main housing (see

59).

Figure 59 – Reinstall the friction-lock screw

Remove the Dovetail Blocks

Use a 2.5mm Allen wrench or driver to remove the

three M3x6 hex socket-head cap screws securing the

right-hand dovetail block to the main housing (see

Figure

60).

Figure 60 – Remove screws from right dovetail block

With the three screws removed, the only thing now

holding the right-hand dovetail block onto the main

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

housing are two M2x8 alignment pins. Remove the

right-hand dovetail block (with the two alignment pins)

by pulling it straight out, away from the main housing

(see

Figure 61

pins back into the dovetail block if necessary.

Figure

Figure 61 – Remove right dovetail block from the housing

Figure 62 – Dovetail blocks with alignment pins

Use a 2.5mm Allen wrench or driver to remove the

three M3x6 hex socket-head cap screws securing the

left-hand dovetail block to the main housing (see

63).

Figure 63 – Remove screws from left dovetail block

With the three screws removed, the only thing now

holding the left-hand dovetail block onto the main

housing are two M2x8 alignment pins. Remove the left-

hand dovetail block (with the two alignment pins) by

and

Figure

62). Reinsert the alignment

Revision 1

Figure

Page 17 of 26