Olympus bx40 Talimatlar Kılavuzu - Sayfa 25

Mikroskop Olympus bx40 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus bx40 33 sayfaları. Replacement illuminator
Ayrıca Olympus bx40 için: Kurulum Talimatları (4 sayfalar)

Sayfayı Yazdır

Fig. 42

Fig. 43

Fig. 44

Use only a PE Photo eyepiece for photomicrography.

Insert the Photo

eyepiece @ with the desired magnification into the straight Photo tube

mounted on the trinocular Observation tube.

(Fig. 43)

Place the Camera unit directly over the circular dovetail of the straight

Photo tube. Make sure the index dots @ on the straight Photo tube and

the Camera unit are aligned, then clamp the unit.

f.2

See page 15 of the "Observation

Tube" section.

1. Camera focusing is done using the binocular section of the trinocular

Observation tube.

+ Whenever

you remove the focusing telescope from the photo-

graphic unit, be sure to install the dust cap.

2. Insert a finder eyepiece into the right eyepiece sleeve.

3. The finder eyepiece has a reticle with four masks and a double crossline,

and the focus is for all purposes the same for the reticle and the Camera

film plane. The masks indicate the areas covered, and the numerals next

to the masks correspond to the magnification of the Photo eyepiece.

Different finder eyepieces are available for different cameras. Select the

type that is appropriate for the Camera being used.

4. Because of the great depth of focus of 1.25X to 4X objectives, use of a

focusing magnifier (U-FT) is recommended for accurate focusing.

0 When using low power objectives, focusing may be accomplished easier

when using the focusing telescope on the Camera unit rather than the

finder eyepiece.