Olympus bx40 Talimatlar Kılavuzu - Sayfa 9

Mikroskop Olympus bx40 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus bx40 33 sayfaları. Replacement illuminator
Ayrıca Olympus bx40 için: Kurulum Talimatları (4 sayfalar)

Sayfayı Yazdır

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Attaching

the Slide Holder

(Fig. 4)

1. Loosen the slide holder clamping screws (iJ to the extent that they

just clear the thickness of the slider holder.

* If the clamping

screws are loosened too much, their threaded

portions

may interfere with the Slots in the slide holder.

2. Insert the slide holder from the front until it Comes up against the stop.

At this Point, make sure the slide holder clamping screws fit into the

positioning Slots on the specimen holder.

* If the slide holder is not fully inserted, it may attach in a tilted Position.

3. Tighten the slide holder clamping screws.

a 1

Mounting

the Condenser

(Fig. 5)

1. Turn the coarse adjustment knob Q) to raise the Stage to its upper limit.

2. Turn the condenser height adjustment knob @ to lower the condenser

holder to its lowest Position.

3. Loosen the condenser clamping screw 0.

4. Position the condenser so that the aperture scale is located in front.

Gently slide the condenser along the dovetail.

5. Tighten the condenser clamping screw and gently raise the condenser

holder to its highest Position.

t When

mounting

the U-SC Swing-out

condenser,

align

the

positioning

pin at the back of the condenser with the groove in the

condenser sleeve.

* When using the U-SC Swing-out condenser or the U-UCDIUCDB

universal condenser,

Swing the top lens out of the way before

inserting the condenser.

Mounting

the Objectivec;

(Fig. 61

1. Turn the coarse adjustment knob to lower the Stage to its lowest position.

2. Mount the objectives on the revolving nosepiece in such a manner that

the magnification increases from low to higher in a clockwise direction.

a .

Mounting

the Observation

Tube

(Fig. 7)

1. Using the Allen screwdriver, loosen the Observation tube clamping screw

2. Insert the circular dovetail mount at the bottom of the Observation tube

into the opening on the microscope frame, placing the Observation tube

to Point the binocular eyepieces

towards the observer.

Clamp the

Observation tube by tightening the clamping screw.

Ir If the direction

of Stage movement

and the direction

of image

movement

differs during observations,

loosen the Stage clamping

screw slightly and adjust the Stage by rotating it, while obser-ving

the image.