Olympus BXFM-ILH Talimatlar Kılavuzu - Sayfa 30

Mikroskop Olympus BXFM-ILH için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus BXFM-ILH 36 sayfaları. Focusing unit

Fig. 27

Fig. 28

Using the Auxiliary Centering Screws

}When the BX-RLA2 or BX-URA2 illuminator is mounted on the BXFM-F focusing unit, it may be impos-

sible to center the aperture iris diaphragm since the focusing unit's coarse adjustment knob is positioned

in front.

...

‡

†

Attaching the Cables and Cords

The cables and cords are vulnerable when bent or twisted. Never

subject them to excessive force.

Make sure that the main switch @ is set to "

necting cables and cords.

1. Insert the hand switch plug @ into the connector ².

2. Insert the lamp housing plug ³ into the connector |.

Always use the power cord provided by Olympus. IF no power cord

is provided with the microscope, please select the proper power

cord by referring to chapter "PROPER SELECTION OF THE POWER

SUPPLY CORD" at the end of this instruction manual.

3. Insert the power cord plug ƒ into the connector ....

4. Insert the power cord plug † into the wall power outlet ‡.

The power cord should be connected to a grounded, 3-conductor

power outlet. If the power outlet is not grounded properly, Olympus

can no longer warrant the electrical safety performance of the equip-

ment.

If a cable or the power cord comes in contact with the lamp housing

or the surroundings, the cable or cord may melt down, causing elec-

tric shock hazards. Be sure to distribute the cables at enough dis-

tance from the lamp housing.

If that is the case:

1. Insert the auxiliary centering screws @ into the AS cen-

tering screw holes on the illuminator.

2. Turn the auxiliary centering screws with the Allen screw-

driver ² (usable from an oblique position because of

its ballpoint design) to center the aperture iris diaphragm.

(Figs. 27 & 28)

" (OFF) before con-