Olympus CX41 Talimatlar Kılavuzu - Sayfa 5

Mikroskop Olympus CX41 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Olympus CX41 32 sayfaları. System microscope
Ayrıca Olympus CX41 için: Genel Bakış (7 sayfalar), Talimatlar (32 sayfalar)

Sayfayı Yazdır

Safety Symbols

The following symbols are found on the microscope. Study the meaning of the symbols and always use the equipment in

the safest possible manner.

Symbol

Warning Label

A warning label is affixed at parts where special precaution is required when handling and using the microscope. Always

heed the warnings.

If the warning label becomes soiled, peeled off, etc., contact Olympus to have it replaced.

Getting Ready

Fig. 2

Indicates that the surface becomes hot, and should not be touched with bare hands.

Before use, carefully read the instruction manual. Improper handling could result in personal

injury to the user and/or damage to the equipment.

Indicates that the main switch is ON.

Indicates that the main switch is OFF.

Warning label

Base underside

position:

(Caution for bulb replacement)

1. A microscope is a precision instrument. Handle it with care and avoid

subjecting it to sudden or severe impact.

2. Do not use the microscope where it is subjected to direct sunlight,

high temperature and humidity, dust or vibrations. (For the operating

environment conditions, refer to and adhere to the conditions specified

in Chapter 5,

3. The tension of the coarse focus adjustment knob should only be

adjusted by means of the tension adjustment ring.

4. Heat from the microscope is led away by natural convection.

Consequently, leave an enough space (10 cm or more) on the rear of

the microscope and ensure that the room is well ventilated.

5. When moving the microscope, carefully carry it with one hand under

the base @ and the other hand holding at the recessed handle on the

rear of the arm ² as shown in the illustration on the left.

#Damage to the microscope will occur if you hold it by the stage, X-

axis/Y-axis knob, binocular section of the observation tube, etc.

Also make sure that eyepieces, specimen, filters, etc. do not fall off.

#Sliding the microscope on the surface of the table may damage or

tear off the rubber feet and/or scratch the table top surface.

Explanation

SPECIFICATIONS

on page 19.)

CX41