Olympus Fluoview FV1000 Kısa Talimatlar - Sayfa 5

Mikroskop Olympus Fluoview FV1000 için çevrimiçi göz atın veya pdf Kısa Talimatlar indirin. Olympus Fluoview FV1000 7 sayfaları. Confocal microscope
Ayrıca Olympus Fluoview FV1000 için: Genel Bakış (28 sayfalar), Kullanıcı Kılavuzu (42 sayfalar), Kısa Talimatlar (7 sayfalar), Kullanıcı Kılavuzu (9 sayfalar), Manuallines (3 sayfalar)

Sayfayı Yazdır

Olympus FV1000

3. Switching on the microscope

1. Follow the procedure by the numbers:

2. Switch on the HBO lamp (no. 1, underneath the computer table).

3. Switch on buttons no. 2 and 3. Microscope stand, laser and scan controllers, and the

computer start automatically.

4. Start the Olympus software: double click on "FV1000 1.7.

5. Select your User ID, type in your password, and press OK.

6. Do not perform the next step until the software start up is completed. If you get any

error messages at this step consult the trouble shooting guide.

7. This microscope provides the following laser lines:



405 nm



440 nm



491 nm



532 nm



559 nm



655 nm

The lasers for 405, 440, and 655 nm are controlled entirely through the Olympus

software. These lasers are switched on by selecting an acquisition protocol from the

dye list in the "Image Acquisition" window or by directly clicking on the laser box in

the "Acquisition Setting" window.

The lasers for 491, 532, and 559 nm have to be switched on manually.

Note, the software will not recognize, if they are not switched on.

Switch on only the lasers you need.

8. To switch on 491 and 532 nm, turn the ignition key (no. 4) to the vertical position. The

LED "LASER ON" will turn green. LED "TEMP LOCK may flash for 60 sec. Then

all four LEDs should be green.

9. To switch on 559 nm (no. 5), wait until the LED 'TEMP' stops blinking. Then turn the

ignition key (no. 5) to the ON position. The red LEDs "Laser" will blink for a few

min. Then they should stay red.

, ..............

-5-

Start".

Short instructions