Axminster UE-125DV Kullanım Kılavuzu - Sayfa 8

Testere Axminster UE-125DV için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Axminster UE-125DV 16 sayfaları. Portable bandsaw machine

Sayfayı Yazdır

DANGER: To avoid electric shock

1. Do not change the power cord and

plug to another specification not

provided by the manufacturer.

2. Do not use in rain or where floor is

wet. This tool is intended for indoor

residential use only.

Motor Safety Protection

CAUTION: To avoid motor damage, this

motor should be blown out or vacuumed

frequently to keep sawdust from

interfering with normal motor ventilation.

Connect this tool with a fuse or circuit

breaker. Using the wrong size fuse can

damage the motor.

If the motor does not start, press the stop

button down immediately. UNPLUG THE

TOOL. Check the saw blade to make sure

it turns freely. If the blade is free, try to start

the motor again.

If the motor still does not start that have to

check the motor's carbon brushes which

can be used 600~800 hours if carbon

brushes has been worn, please change the

new one.

If the motor suddenly stalls while cutting

material, press the stop button off, unplug

the tool, and free the blade from the steel

Then you may restart the motor and finish

the cut.

Fuses may "blow" or circuit breakers may

trip frequently if:

Motor is overloaded-overloading can

occur if you feed too rapidly or make

too many start/stops in a short time.

Voltage not more than 10% above or

below the nameplate voltage can

handle normal loads. For heavy loads,

however, the voltage (caused by a

small size wire in the supply circuit or

an overly long supply circuit wire) may

drop too low for the motor to operate.

Always check the connections, the

load and the supply circuit whenever

motor does not work well. Check wire

sizes and length with the Wire Size

Chart below.

Most motor troubles may be trace to loose

or incorrect connections, overload, low

voltage (such as small size wire in the

supply circuit) or to overly long supply

circuit wire. Always check the connections,

the load and the supply circuit whenever

motor doesn't work well. Check wire size

and length with the Wire Size Chart below.

Wire Sizes

The use of any extension cable will cause some

loss of power. To keep this to a minimum and to

prevent overheating and motor burn-out, use the

table below to determine the minimum wire size

(lead cross-section) of an extension cable.

For circuits that are more than 40m away from

the electrical service box, the wire size must be

increased proportionately in order to deliver

ample voltage to the saw motor.

Length of the

Conductor

up to 15m

15-40m

5. Unpacking and Checking

Contents

The Metal Saw is shipped complete in one

carton. Separate all parts from packing material

and check each item with illustration and Make

certain all items are accounted for, before

discarding any packing material.

WARNING: If any parts are missing, do

not try to assemble the metal saw, plug

in the power cable or turn the switch on

until the missing parts are obtained and

installed correctly.

Item

Attached Parts

Stop Rod Assembly (E) Fig.4

Instruction Manual

- 6 -

Wire Sizes Required

For 220V

1.5mm

2.5mm

Fig. 4

Q'TY

1set