Axminster RTC7030 Kullanıcı Kılavuzu - Sayfa 8

Araçlar Axminster RTC7030 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Axminster RTC7030 16 sayfaları. 305mm & 750mm sheet metal workers

Sayfayı Yazdır

Operating Instructions...

A X M I N S T E R

W H I T E

The basic operation of the machine is as follows. The operating handle is attached to a

shaft which serves two functions; firstly it drives the three rollers which carry out the rolling

operation and secondly, with the aid of eccentrics, mounted at the two ends, it raises and

lowers the lower cross bar of the machine. Mounted on the top of this cross bar are the

female bending dies whilst the lower edge carries the upper shear blade. The male bending

dies are fixed to the static cross beam and the lower shear blade is fixed to the table on

which the work is supported. Thus, as the handle is operated, the rolls rotate to form

cylindrical items whilst the main beam goes up and down to either form bends between the

two dies or to shear material between the moving and fixed blades.

Shearing

Shearing can be carried out either by positioning the material between the blades by eye

using a line marked on the sheet or by using the adjustable backstop for more precise

results.

To fit the backstop assembly, screw the two rods into the rear of the static cross beam

(see fig 5), fit the two blocks to the backstop bar with two hex screws (see fig 6) and slide

the bar onto the two rods (see fig 7). The two clamping screws are used to secure the

backstop in the required position on the two rods. Please note that the flange of the

backstop bar should be positioned downwards.

If a precise 90 deg angle is required, the guide block can be fitted to the right hand side of

the table using hex screws. (see fig 8). The guide block should be set square to the lower

blade using an engineer's square.

To carry out the shearing operation, raise the cross beam to its highest position, slide the

material in between the blades, position it correctly either with the marked line or up against

the back stop and rotate the operating handle to make the cut.

NOTE: If you find that the rollers are not rotating all the way round while sheet

bending, it's because the pressure plate that clamps the material during

shearing, binds up on it's springs & the handle can not be turned completely

over. If this accrues, remove the pressure plate.

Bending

As with the shearing operation, bending can either be carried out by lining up the work by

eye or by positioning it with the help of the backstop. If the backstop is to be used it should

be positioned in the upper holes (see fig 7) and the backstop bar reversed so that the

flange is upwards.

Having positioned the workpiece correctly between the bending dies, rotate the handle to

bring the dies together to form the bend. The angle of the bend, up to a maximum of 90

deg., is controlled by limiting the travel of the upper die. If repetition work is to be carried

out then the bend angle can be set by adjusting the height of the cross beam using

adjusting screws shown (see fig 9b).

If it is required to bend only part of the workpiece, as shown in fig. 9, then the appropriate

sections of the upper die can be removed by undoing the hex bolts (see Fig. 9a). When

forming this type of bend it will be necessary to notch the corner as shown in figs 10 & 10a

to achieve the required result.