Axminster ZQJ4125K Manuel - Sayfa 14

Elektrikli Alet Axminster ZQJ4125K için çevrimiçi göz atın veya pdf Manuel indirin. Axminster ZQJ4125K 18 sayfaları.

1. Turn the nut indicated by the arrow in Figure 16, in a clockwise direction. This will draw

the location pin out of the casting. Once loose, pull the pin and nut out, and set it in a

safe place until needed.

2. Loosen the large bolt in the center of the support bracket.

3. Rotate the bracket to the desired angle. Use the scale on the side of the bracket or a

protractor to set the angle. Lock in place by tightening the bolt.

When repositioning the table to 0° position, loosen the large bolt in the center of the

support casting. Rotate the support casting until the degree scale reads 0°. Carefully tap

the location pin back into the hole from which it came until it stops. Unscrew the nut on the

location pin until it is flush with the end of the threads. This will protect the threads when

you tap it into place with a hammer. Turn the nut clockwise until it is snug against the

casting and then tighten the large bolt in the center. The table is now set to the factory

pre-set angle.

5: OPERATIONS

Once assembly is complete and adjustments are done to your satisfaction, you are ready

to test run the machine.

Turn on the power supply at the main panel. Flip the START button. Make sure that your

finger is poised on the paddle switch, just in case there is a problem. The drill press should

run smoothly, with little or no vibration or rubbing noises. Strange or unnatural noises

should be investigated and corrected before operating the machine further.

If you cannot easily locate the source of an unusual noise or vibration, contact our service

department for help.

Make sure to secure the bit firmly in place. When changing bits, proceed as follows:

1. Disconnect the machine from power source.

We reserve the right of the amendment addition and deletion of the

specifications, explanatory wording, etc. printed in this manual

PDF 文件使用 "pdfFactory Pro" 试用版本创建

DRILL PRESS MANUAL

Figure 16

www.fineprint.cn

Figure 17