AccuPower IQ-328 Kullanım Talimatları Kılavuzu - Sayfa 5
Akü Şarj Cihazı AccuPower IQ-328 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AccuPower IQ-328 9 sayfaları. Intelligent fast charger
Sayfayı Yazdır
Note:
• Always follow the battery manufacturer's directions and pay attention to the
recommended maximum charging current. Basically a charge current of 200 mA
is recommended, this is a safe and optimal value for each battery, when rapid
charging is not necessary.
• When you buy new batteries, it is possible that they have to be formatted first in
order to reach optimal performance. You can do this by the REFRESH function
(see page 7).
• The charging current can not be changed during the charging process. This will
prevent accidental setting change.
•
When the power supply was connected to the socket before a battery is inserted,
then all the segments will shown for a short time and it will be "null ". If a low
discharged battery or defective battery is inserted, will be also "null " on the LCD
display.
• If there is any overheating (temperatures above 55 ° C, usually triggered by a too
high charge current), the charging process is stopped and the display shows "000
mA ". Only after the temperature dropped to a safe level, the charging process
continues. In case are repeated the overheating, the batteries must be removed
to cool down and then restart with an new lower current.
DISCHARGING "DISCHARGE"
When you Select the discharge function (DISCHARGE), the inserted batteries are first
discharged, then charged. So the memory effect is avoided. To select such Function,
after inserting the battery, hold down the MODE button for about three seconds. The
discharge current, you can select by using the CURRENT button. (see table below)
"null" wird angezeigt – Es ist entweder kein Akku oder ein defekter Akku eingelegt.
"null" displayed - No battery or damaged battery is placed to the charging unit
Wenn der Akku eine Temperatur über 55°C hat und der
Ladevorgang stoppt, es wird "000 mA" angezeigt.
When the battery is overheated over about 55°C the
charging will ceases automatically. It will be shown "000 mA"
"000 mA" will be displayed.
5/8