Arc Euro Trade SC3 Sökme ve Takma Kılavuzu - Sayfa 5

Torna Tezgahı Arc Euro Trade SC3 için çevrimiçi göz atın veya pdf Sökme ve Takma Kılavuzu indirin. Arc Euro Trade SC3 17 sayfaları.

Sayfayı Yazdır

Dismantling the spindle

Steps 34 to 77 include a bearing change from standard ball raced bearings to taper roller bearings. Switching to taper roller bearings will improve the machining

accuracies and finish.

Since in many cases, taper roller bearings are not an essential upgrade, and because you will need access to another lathe, a hydraulic press and

bearing separator you may wish to keep the standard ball races and skip forward to step 77.

34. Remove the power board cover.

36. Remove 4 screws retaining the control panel and lay it down beside the machine.

38. Disconnect power cables and guard

switch wires.

40. Remove motor end cover and mains cable

39. Remove the motor cover and pull power cables through from front of machine.

41. Remove the power board

- 5 -

35. Disconnect the mains leads.

37. Disconnect the earth leads.