CIOKS 9000-0012-1863 Hızlı Başlangıç Kılavuzu - Sayfa 2
Güç Kaynağı CIOKS 9000-0012-1863 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. CIOKS 9000-0012-1863 9 sayfaları. Attaching of power supply to a pedaltrain board
Sayfayı Yazdır
CIOKS / Eventide PowerFactor 2 power supply underneath or on top of a Pedaltrain board.
Clearance for the fan on the back
When mounting the PowerFactor 2 underneath a PT-Jr, PT-1 or PT-2 we recommend placing of the unit in a
position, so the fan on the back of the unit is aligned with one of the two holes in the back part of the pedal
board. This ensures free passage of air in heavy load situations, where the fan is automatically activated.
With PT-3, PT-Pro and PT-Grande there are no holes, since the back of the board consists of two profiles,
and free air passage in-between them is ensured in any position of the power supply.
What is included with a link range power supply and what else will you need?
With the power supply unit you get four screws, four spring washers, four stand-offs and a hex key. All
these parts shown below are in a little zip-bag included with the power supply in the black cardboard box.
Not all the listed tools are strictly necessary but it's nice to have: pair of scissors, scotch tape, hammer,
centre punch, ø4-5mm drill bit and a drill driver to follow this guide.
Underneath a Pedaltrain pedal board
Following step-by-step guide shows how we mounted the PowerFactor 2 power supply underneath a
Pedaltrain PT-2 pedal board. The procedure is exactly the same with other Pedaltrain models.
First attach the four stand-offs to the treaded holes in the bottom of the power supply as shown on the
pictures below. The spring washers should be placed between the power supply and the stand-offs. You
don't have to remove the rubber feet when mounting the power supply underneath a Pedaltrain board.
Tighten the stand-offs firmly with your fingers, they'll be tightened more in the end when you use the key.
Page 2