Accurate Technology Digi-Stop Kullanıcı Kılavuzu - Sayfa 10

Ölçüm Cihazları Accurate Technology Digi-Stop için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Accurate Technology Digi-Stop 16 sayfaları. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws

Sayfayı Yazdır
illuminated bar indicates an additional 1/64 of an inch of measurement.) For
better resolution, switch to 1/32 or 1/64 mode. For the best resolution and
accuracy switch to a decimal mode – inches or millimeters..
When the measurement is greater than 99 63/64 inches, a +100
will illuminate in the upper right portion of the display to indicate this amount
must be added to the displayed reading. ie: If the measurement is 154 5/8
inches, 54 5/8 and +100
is -307 23/64 inches, - 7 23/64, +100
display.
+,
, and -
DATUM
The
+
(plus),
DATUM
displayed position to a different value. The
display a user programmed value.
Momentarily depressing the
of measurement. Momentarily depressing the
position by one unit. Pressing and holding the
displayed position to change continuously. Holding down the key will cause the
amount of change to speed up. This allows for quick adjustments over a range
of large values.
NOTE: While the
displayed value, it can also be programmed to force the readout to a preset
value. This can be zero, or any other displayable value.
See Section 3: Readout Programming,

Reverse Readings

Reverse readings means changing the direction of readings produced by
moving the stop. If the DigiStop decrements (reduces or goes negative) when
it should be incrementing (increasing or going positive), the readout will need
to be re-programmed for your installation (right vs left infeeds).
See Section 3: Readout Programming,
Manual Part # 800-1070-001, Rev G, 10-2008
+100 will be illuminated on the display. If the measurement
+100
+100
+100 and +200
+100
+100
and
–
(minus) keys are used to change the currently
+
key increments the current position by one unit
key can be used to simply "zero" the currently
DATUM
+200 will be illuminated on the
+200
+200
DATUM
Programming Parameter Pr1
–
Programming Parameter Pr1.
Programming Parameter Pr2.
+100
+100 and/or +200
+100
key forces the readout to
key decrements the current
+
or
–
keys will cause the
Page 10 of 16
+200
+200
+200