Accurate Technology Digi-Stop Kullanıcı Kılavuzu - Sayfa 12
Ölçüm Cihazları Accurate Technology Digi-Stop için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Accurate Technology Digi-Stop 16 sayfaları. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws
Sayfayı Yazdırkeys to provide a different offset. Moving the stop in either direction will
display the distance moved from the initial INC starting point (plus any offset).
To complete another incremental measurement from the new position,
momentarily press the
previously programmed offset). To return to the ABS mode, press and hold
the
key for approximately 3 seconds.
UNITS
NOTES: when the readout is in incremental measuring mode the
longer functions to change the measurement units displayed.
The absolute position of the Digi-Stop is not lost when using the incremental
mode. When the readout is switched back to the absolute mode the readout
reflests the current stop position relative to your original calibrated absolute
setting.
Circuit board Jumpers
The Digi-Stop readout has several user configurable jumpers consisting of
three pins and a 'shorting block or jumper'.
The center of these three pins is 'Common'. One end pin is labeled A and the
other end pin is labeled B.
JP1
JP2
Manual Part # 800-1070-001, Rev G, 10-2008
key. The readout will again change to 0 (or the
UNITS
JP1
FACTORY USE ONLY
Programming Lockout
Position A, Front Panel Programming is ENABLED
Position B, Front Panel Programming is DISABLED
JP2
key no
UNITS
Page 12 of 16