Arcam DiVA P80 Manuel - Sayfa 4

Amplifikatör Arcam DiVA P80 için çevrimiçi göz atın veya pdf Manuel indirin. Arcam DiVA P80 9 sayfaları.

Using your P80 power amplifier

POWER (and power indicator light)

Switches the unit on and off. The light indicates the status of the

amplifier.

When you switch your amplifier on, the light glows amber for a

few seconds, during which time the speakers are disconnected.

The light changes to green when the amplifier is ready for use. A

red light means the amplifier is in standby mode.

The light may flash if a fault has occurred somewhere in the

system (the fault type is shown on the front panel display of

the A80). You should unplug the amplifier and leave it for a few

minutes before reconnecting. If the fault cannot be cleared,

unplug your amplifier and contact your Arcam dealer.

SP1 and SP2

These buttons allow you to select and deselect the main

(

SP1

amplifier.

NOTE: If both lights are out the amplifier will appear not

to work, as all speakers are switched off. If both are on,

overloads are more likely if low impedance speakers are

connected.

SP1

SP2

) and secondary (

) sets of speakers attached to your

SP2

A80 POWER AMPLIFIER

POWER

A80/P80