Arcam DiVA P80 Manuel - Sayfa 6

Amplifikatör Arcam DiVA P80 için çevrimiçi göz atın veya pdf Manuel indirin. Arcam DiVA P80 9 sayfaları.

Sayfayı Yazdır

Service information

Before returning your amplifier for service, please check the

following:

Sound cuts out for no reason

If the temperature of the internal heatsink rises above a safe

level, then a thermal cutout inside the amplifier will operate.

The power indicator on the front panel flashes and the

protection system temporarily removes the power to the

speakers. The system resets after the heatsink has cooled

down.

Technical specifications

Continual improvement policy

Arcam has a policy of continual improvement for its products.

This means that designs and specifications are subject to

change without notice.

Continuous power output, per channel

Both channels, 8Ω, 20Hz–20kHz

Single channel, 4Ω, 1kHz

Distortion, 8Ω, 80% power, 1kHz

Inputs

Phono cartridge input sensitivity, MM

Line and tape inputs:

Nominal sensitivity

Input impedance

Signal/noise ratio (CCIR)

Preamplifier outputs

Nominal output level

Output impedance

General

Power consumption (maximum)

Dimensions W x D x H (including feet)

Weight (net)

Weight (packed)

Supplied accessories

E&OE

Note that because of the high output voltage from a CD player,

it is possible to drive the A80 at full power even though the

volume is not set at maximum.

Amplifier does not switch back on

The A80 and P80 amplifiers have a protection mechanism

which is activated if you switch the unit on immediately after

turning it off. If this mechanism activates, wait 30 seconds then

switch back on again.

A80

65W

140W

0.005%

2.5mV

250mV

22kΩ

105dB

700mV

<50Ω

650VA

430 x 330 x 75mm

9kg

10kg

mains lead

CR-389 remote control

2 x AAA batteries

NOTE: All specification values are typical unless otherwise

stated.

P80

65W