DigiDesign FWx FireWire Manuel - Sayfa 11
Kayıt Ekipmanları DigiDesign FWx FireWire için çevrimiçi göz atın veya pdf Manuel indirin. DigiDesign FWx FireWire 18 sayfaları.
Sayfayı YazdırGently slide the card into the expansion slot. Make sure it is
7
oriented right-side up.
Installing the FWx card in the back of the Mix Rack
Secure the FWx to the back of the Mix Rack using the screws
8
that secured the expansion slot cover.
Secure the FWx card to the Mix Rack's chassis by tightening
9
the captive thumbscrews (accessible from the open front
panel of the Mix Rack).
Securing the FWx card to the Mix Rack's chassis
Cut the zip tie that secures the expansion card power cable
10
to the chassis, being careful not to cut the wires.
Cutting the expansion card power cable zip tie
Attach an available internal power cable plug to the power
11
socket on the FWx card by holding the socket on the FWx and
pushing the plug firmly into the socket. When the power ca-
ble plug is correctly attached to the FWx card, the yellow wire
should be the first wire from the left.
Attaching an internal power cable plug
Chapter 2: Installing FWx 7